The Moroso Aluminum Breather Catch Can with Roll Bar Mount is a premium setup for your race car. The breather tanks are packed full of features to not only function correctly, but also finish off the professional look of your engine compartment better than the typical and cheap-looking beer or energy drink can...
- 3/8" NPT inlet
- Use as a remote breather/oil separator on dry sump tanks, rear axle housings, etc.
- Rollbar mounting brackets
- Comes complete with filtered breather, and drain cock
- Internal baffle (mesh media) to prevent sloshing and provide better separation of fluid and air
- Dimensions: 3-1/8" diameter, 6-1/2" tank height without filter (11.5" overall)
Made in USA
Notice of Emissions Non-Compliance. This product is intended only for racing vehicles that may never be used, or registered or licensed for use, upon a public highway. Removing, disabling, or altering emissions equipment on a pollution-controlled road vehicle is illegal. It's use is prohibited in any motor vehicle that is subject to emissions inspection or control. It is not legal for installation or use on any pollution controlled motor vehicle in any state, province, or jurisdiction governed by, or which has adopted, CARB or EPA regulations. BimmerWorld may confirm a customer's racing license, entry, track participation, and we may ask for photos or proof of a permanent race car build. We reserve the right to cancel part(s) that are not for legitimate racing or track purposes.
